TAMS 70488 PCI GPIB interface for HP-UX 10.20
|
|
The TAMS 70488 is fully
compliant with the PCI specifications for 3.3V and 5V
PCI/PCI-X slots. The card operates with 32 bit or 64 bit
signaling specified at 33, 66, 100 or 133MHz, allowing
complete configuration flexibility.
|
|
|
TAMS 70488 is a functional
replacement for the HP/Agilent E2078A PCI GPIB Card. |
|
|
General Requirements:
| Minimum
System Requirements: |
HP-UX 10.20. (Use the 71488
for HP-UX 11i)
Series 700 workstation, (1) available PCI
slot, and the SICL/VISA
I/O Libraries 72091. |
| Supported Standards: |
PCI, PCI-X, IEEE-488.1 and
IEEE-488.2, SICL, VISA |
| Supported Software
Development: |
BASIC/UX, ANSI-C, Agilent
VEE Pro |
| |
|
|
General Characteristics:
| Dimensions: |
150 mm x 155 mm x
7mm including connectors |
| Weight: |
125 grams |
| Maximum
I/O speed: |
1MB/s. |
| PCI: |
3.3 or 5v; 32
bit or 64 bit signaling; 33, 66, 100 or 133MHz; PCI or
PCI-X |
| Power: |
+5V 500 mA (max), 390 mA (typical) |
| Connector: |
Cannon 25
position Microminiature Connector. |
| Cable: |
TAMS
488 (see below) |
| Warranty: |
1 Year |
| |
|
|
Environmental Specifications:
| Operating Environment: |
0 degrees C to +40
degrees C |
| Storage Environment: |
-20 degrees C to +60
degrees C |
| Humidity: |
20-80% (0 degrees C to
+40 degrees C) |
| Storage Humidity: |
20-80% (0 degrees C to
+55 degrees C) |
| |
|
|
Ordering Information:
| Model #: |
70488 |
| Price: |
$1,145.00 (Limited to stock on hand) |
| Standard Shipped Components: |
(1) 70488 PCI GPIB Interface.
(1) TAMS I/O Library for HPUX License to Use.
(p/n: 72091-0700)
(1) Operation Instructions for HP-UX.
(1) Driver Software for HPUX 10.20 CD-ROM.
TAMS 488 cable and Media CD for I/O Library
are not included and should be
ordered separately if needed. |
TAMS 488 Cables:
Our cable is a high density connector on one
end and a standard GPIB connector on the other.
Our card uses a smaller, high density connector
so as to be in full compliance with the PCI
specification. A standard GPIB connector
on a PCI card is actually wider than the PCI
specification allows. With a standard GPIB
connector and cable, it is sometimes impossible
to connect the cable to some computers.
The large connectors often interfere with the
case or adjacent expansion slots. This
stresses the cable, card or connection. Our high
density connector allows multiple cards to be
installed in adjacent slots without cable
interference or connection strain. |
HP-IB Cable with high density connector
| 488-001 |
2-meter |
$98.00 |
| 488-004 |
4-meter |
$135.00 |
| 488-006 |
6-meter |
$155.00 |
|
|
| |
|
|
|
Documentation:
|
